Conversion Process - Electrical - Controlling the controller......
First go at looking at the Alltrax ControlPRO management software.....
(A few screen dumps below)
Control Panel Options
Throttle Response Adjustments
And the Monitor tab - You can display real time data in the monitor screen (as shown above) but you need to have the controller powered up prior to starting the software and while you are displaying data. This is a pain as every time the foot pedal is released you lose the connection to the controller and the software reports the no controller found message. Not sure if there is a work around will check with Alltrax.
(Solution was to add a "Service" switch (key style) in parallel with the micro switch on the pot box - Simple! Thanks to DIY forum.....)